File Recovery Software Users Guide

Contents > Procedures

 5. USING COMMAND-LINE PARAMETERS
 

This chapter describes how to use the application with command line parameters.

5.1. Overview of Command Line Parameters

Active@ UNERASER DOS console supports a set of command line parameters. To view them and their definitions, type:

A:\>UNERASER -?

Table 5-1 Command Line Parameters

Parameter

Description

Note

No parameter

The DOS Interactive screens appear.

-?

Question mark

The table of parameters appears.

-writelog[=fullpath]

Create a log file with debug information

-writetest[=fullpath]

Create a file containing hardware configuration

 

-retries=[0...99]

When an error is detected, the utility attempts to read and write the area this number of times before moving on.

 

Previous < Contents > Next

 

Home  |  Partners  |  Order  |  Products  |  About Us

©  1998-2008  Active@ Data Recovery Software